Skip to main content
Version: 028-rc16

Flashing: Toradex Verdin iMX8M Mini

Flash method: UUU via pv-flash-bundle — see toradex.md

Image artifact: pv-flash-bundle-verdin-imx8mm.tar.gz

Entering USB serial download (SDP) mode​

The Verdin SOM enters SDP mode when the RECOVERY# signal is held low during power-on. The exact mechanism depends on the carrier board.

Verdin Development Board​

  1. Connect a USB-C cable from the board's USB-C (OTG) port to your host PC.
  2. Hold the Recovery button while applying power (or while pressing Reset).
  3. Release the button after ~1 second. The module enumerates on the host as an NXP SDP device (ID 1fc9:0146).

Verify detection:

sudo ./uuu -lsusb
# Expected: SE Blank ARIK  or  SDP:MX8MM

Other carrier boards​

The general procedure is the same: pull RECOVERY# low during power-on. Consult the Toradex developer documentation for your specific carrier board.

Supported carrier boards and device trees​

The default build targets the WiFi variant on the Development Board. Change UBOOT_DTB_NAME in kas/machines/verdin-imx8mm.yaml to match your carrier board:

Carrier boardUBOOT_DTB_NAME value
Development board (default)imx8mm-verdin-wifi-dev.dtb
Ivy boardimx8mm-verdin-wifi-ivy.dtb
Mallow boardimx8mm-verdin-wifi-mallow.dtb
Yavia boardimx8mm-verdin-wifi-yavia.dtb

Flashing​

With the module in SDP mode, follow the procedure in toradex.md — Flashing procedure.

Notes​

  • WiFi is enabled (TORADEX_VARIANT = "wifi"); cfg80211 and mwifiex_sdio are autoloaded.
  • PV_UBOOT_AUTOFDT = "1" is set; the runtime DTB is pinned by UBOOT_DTB_NAME. If you switch carrier boards, update UBOOT_DTB_NAME in the machine YAML before building.
  • eMMC (MMC0) is the primary storage. The pv-flash-bundle writes to it directly via UUU raw-sparse flash.